Velleman Kits & Projects

A small panel mounted thermostat with LED indication, uses 3-wire sensor for accurate indication and control of temperature. Suitable for controlling room or incubator temperatures. Features: general purpose panel mount thermostat, usable for heating or cooling purposes, (central heating, airco, incubator,… ), separate output-ON and output-OFF setting (hysteresis), direct manual temperature adjustment, bright red LED read-out, comes with easy board-to-wire connectors and sensor (20cm wire), calibrate option, under- and overflow indication

Mains operated timer, suited for turning on an extractor fan and allowing to run for approx 3 minutes or switching off after 7-15 minutes after the mains power has been removed. Other uses could include operation outside lighting or security applications.

Pocket Audio Generator Module. Microprocessor technology. Digital waveform generation

Velleman VM160 module is a mains operated 4-channel RF receiver which is supplied with VM160T a 4-channel RF transmitter. The VM160 can be operated from VM160DT a desk top RF transmitter. With approximately a 30m operating range this module has many uses.

Velleman VM160 module is a mains operated 4-channel RF receiver which is supplied with VM160T a 4-channel RF transmitter. The VM160 can be operated from VM160DT a desk top RF transmitter. With approximately a 30m operating range this module has many uses.

Just put in series and add one or more pushbuttons and you are set.

This 2-Channel RF Remote Control is compatible with with various Velleman receivers: VM130, VM151, VM152, VM162, K8057

DIN rail mounting 0 - 10V RGB dimmer. By altering control voltage between 0 - 10V or 1 - 10V the brightness of the LED can be varied with LED status indication. Multiply the output power of your Velleman LED controller with VM169

The VM200 can detect Beta and Gamma rays, it will emit a beep sound to indicate the presence of radiation. The stronger the radiation level the quicker the speed of the beeps. It is a small compact device and supplied with pocket clip.

The card simply connects to your router by means of a standard network cable. You can operate the 8 relays or check the status of the input from anywhere in world. The card is web server based, so almost any internet browser can connect to the card, even mobile devices. No additional software installation required. The unit has numerous extra features such as reports by email at power up or input status change, programmable timers for each output, labeling of outputs etc…